Cisco - Exclusive Limited Time Discount Offer - Ends In 00:00:00 Coupon code: 30OFF
  1. Home
  2. Cisco
  3. 300-610 Exam

Free 300-610 Questions for Cisco 300-610 Exam as PDF & Practice Test Software

Page:    1 / 14   
Total 204 questions

Question 1

An architect must automate routine tasks within a data center The data center exclusively uses Cisco Nexus Series Switches The networking team lacks proper programming knowledge and prefers an automation solution that leverages NXOS commands Any configuration change must use HTTPS for transport due to a security compliance requirement. Which solution must the architect choose?

Answer : A

Question 2

Refer to the exhibit A company plans to implement high availability between the iSCSI host and the Fibre Channel target. Which solution must the company implement to recover from a failure of a host NIC. MDS IP storage port or Fibre Channel target port?

Answer : C

Question 3

Refer to the exhibit In this scenario a Cisco engineer is building a loop-free topology where a dedicated layer of the vPC domain adjacent to the aggregation layer which also runs vPC Is used to interconnect the two data centers together. The engineer globally configures a vPC domain identifier on both vPC devices where the domain ID is the same on both peer devices. Which action successfully forms the domain?

Answer : A

Question 4

Refer to the exhibit.

An engineer is configuring a QoS policy with these requirements

Match-all AF11 traffic and set it to a DSCP value of 14.

The committed rate must be 10 Mbps with a committed burst rate of 1000 ms

Drop any AF11 traffic that violates these settings.

Any traffic other than af11 must have a DSCP value of 0

The given class-map configuration already exists. Which solution must the engineer use to meet the requirements?





Answer : C

Question 5

A customer attaches an additional storage appliance to an existing Cisco UCS domain, which contains 50 virtualization hosts that require fabric failover connectivity on fabric interconnect B. The interfaces are bound to a separate pin group to segregate traffic with a CoS value of 0 Which Cisco UCS Manager feature meets these requirements?

Answer : D

Page:    1 / 14   
Total 204 questions