CWNP - Limited Time Discount Offer - Ends In 1d 00h 00m 00s Coupon code: Y2430OFF
  1. Home
  2. CWNP
  3. CWNA-108 Dumps
  4. Free CWNA-108 Questions

Free CWNA-108 Questions for CWNP CWNA-108 Exam as PDF & Practice Test Software

Page:    1 / 14   
Total 60 questions

Question 1

You were previously onsite at XYZ's facility to conduct a pre-deployment RF site survey. The WLAN has been deployed according to your recommendations and you are onsite again to perform a post-deployment validation survey.

When performing this type of post-deployment RF site survey voice over Wi-Fi, what is an action that must be performed?



Answer : C


Question 2

You are troubleshooting a client problem with a 2.4 GHz WLAN connection. The client is experiencing surprisingly low data rates during the work day. You analyze the workspace outside of business hours and detect a strong signal with a typical noise floor at the client location. During working hours, the user works with a laptop in the area and uses an external USB hard drive for continuous data access. The user also states that the laptop works as expected on her home network. The user working approximately 8 feet away from this client experiences no problems.

Based on this information, what is the likely cause of the problem?



Answer : D


Question 3

In addition to coverage analysis results, what should be included in a post-deployment site survey report to ensure WLAN users experience acceptable performance?



Answer : B


Question 4

You are troubleshooting a client issue on a Windows laptop. The laptop can see and connect to 2.4 GHz APs, but is does not even see 5 GHz APs. While evaluating the issue, you determine that this problem is happening for all of the laptops of this model in the organization. Several other tablets connect on channel 48 and channel 52 in the same work areas. What is the likely problem?



Answer : C


Question 5

A client complains of low data rates on his computer. When you evaluate the situation, you see that the signal strength is -84 dBm and the noise floor is -96 dBm. The client is an 802.11ac client and connects to an 802.11ac AP. Both the client and AP are 2x2:2 devices. What is the likely cause of the low data rate issue?



Answer : A


Page:    1 / 14   
Total 60 questions