Question 1

Which of the following best describes the order in which this should be carried out?

a.Decide which category of test design technique to use.

b.Review test specifications.

c.Write test procedures.

d.Create test cases.

e.Identify test conditions.

Aa, b, d, e then c.

Bb, e, a, d then c.

Cb, a, d, c then e.

De, b, a, d then c.

Answer : B

Question 2

Which of the following provides the best example of a product risk leading to a project risk?

AThe signalling systems may have more defects than anticipated, leading to the need for more retesting to be carried out.

BThere may be unexpected lags on the network traffic communication, causing drivers to slow the trains down unnecessarily.

CThe new development staff may require training for this type of system, which, if not carried out, may lead to an increase in the number of defects introduced.

DThe budget may need to be increased significantly during the project, otherwise there may be delays in the delivery of the system.

Answer : A

Question 3

Which of the following best describes the difference between the use of walkthroughs and inspections in this scenario?

AWalkthroughs of specifications would enable the individuals to learn more about the system being developed, whilst inspections would allow the organization as a whole to improve.

BWalkthroughs of signalling rules will be more cost effective than inspections.

CInspections of code should be carried out by the developers, whilst code walkthroughs should include just the testers.

DA walkthrough is an example of a static testing technique, whilst an inspection is an example of a dynamic testing technique.

Answer : A

Question 4

Which two of the following measures would give the best indication of likely product quality?

a. Number of hours of overtime worked.

b.Number of test runs.

c.Coverage of requirements achieved.

d.Defect trends.

e.Budget sent so far.

Aa and c.

Bb and d.

Cc and d.

Dd and e.

Answer : C

Question 5

At what point in the test process should you first consider the test environment required for the project?

AWhen writing the test policy.

BWhen writing the test strategy.

CWith designing the test cases.

DWhen writing the test procedures.