Question 1

Your customer has an HPE Synergy frame equipped with a D3940 Storage Module. Each of the compute nodes has an appropriate storage controller Installed and two 12Gb SAS switches installed in the first fabric.

The customer reports that compute nodes cannot access the storage module. What should you verify first when troubleshooting this problem?

AIf the D3940 module is imported in managed state that allows volume provisioning.

BIf there Is a logical interconnect created based on the 12Gb SAS switches.

CIf the D3940 storage module is property licensed through HPE OneView interface.

DIf there is at least one ISCSI network configured that will provide access to the module.

Answer : A

Question 2

You need to configure a RoCE network to enable lossless networking for HPE J2000 Flash Enclosure support Which interconnects are required to support this connection? (Select two.)

AHPE Virtual Connect SE 40Gb F8 Module for HPE Synergy

BHPE Virtual Connect SE 16Gb FC Module for HPE Synergy

CHPE Virtual Connect SE 100Gb F32 Module for HPE Synergy

DHPE Virtual Connect SE 32Gb FC Module for HPE Synergy

EBrocade 16Gb Fibfe Channel SAN Switch Module for HPE Synergy

FBrocade 32Gb Fibre Channel SAN Switch Module for HPE Synergy

Answer : B, D

Question 3

Which statement about the SY480 Gen10 Plus Compute Module is true?

AIt cannot be mixed with Gen9 compute modules in the same frame.

BIt supports 8 memory channels and memory DIMMs of up to 256GB.

CIt only supports NVDIMM Persistent Memory.

DIt supports '3rd Gen AMO EPYC Server Processors with 64 cores.

Answer : C

Question 4

What is a restriction of using a RoCE network?

AIt is by default configured as an untagged network and cannot be a part of a network set.

BIt does not support Private VLAN and Multicast VLAN.

Cit is not supported with HPE Virtual Connect SE 40 GD F8 Module for HPE Synergy.

DIt does not support smart link and private network features.

Answer : A

Question 5

Your customer plans to deploy VMware ESXi 7. 0 U2, and they are looking for a hardware platform that will allow them to use up to 16 CPU sockets

Which HPE compute system meets the customer requirements?

AHPE ProLiant DL580 Gen10

BHPE ProLiant OL380 Gen 10 Plus

CHPE Synergy 480 Gen10 Plus

DHPE Superdome Flex system