Huawei - Exclusive Limited Time Discount Offer - Ends In 1d 00h 00m 00s Coupon code: 30OFF
  1. Home
  2. Huawei
  3. H12-711_V3.0 Dumps
  4. Free H12-711_V3.0 Questions

Free H12-711_V3.0 Questions for Huawei H12-711_V3.0 Exam as PDF & Practice Test Software

Page:    1 / 14   
Total 492 questions

Question 1

If the company network administrator needs to check the status of the heartbeat interface after configuring the company's dual-system hot backup, the command he needs to type is ( ) The system view has been entered by default) (fill in the blank)

See Below Explanation:




Answer : A

Question 2

( ) means that the computer system has defects and deficiencies in the specific matters of hardware, software, protocols or system security policies. (Chinese Standard Terminology) (fill in the blank)

See Below Explanation:




Answer : A

Question 3

To configure a NAT policy in command line mode, you need to use the .command ( ) in the system view to enter the NAT policy configuration view. (all lowercase) (fill in the blank)

See Below Explanation:




Answer : A

Question 4

When the company network administrator configures dual-system hot backup, (fill in the blank) configure the status of VRRP backup group l as Active, and configure the virtual IP address as 10.1.1.1/24

system-view

[sysname] interface GigabitEthernet 0/0/1

[sysname-GigabitEthernet0/0/l] ( ), the command to be typed in the blank is (please fill in the complete command in all lowercase)

See Below Explanation:




Answer : A

Question 5

The SIP protocol uses the SDP message to establish a session, and the SDP message contains the remote address or multicast address



Answer : A

Page:    1 / 14   
Total 492 questions