Click the Exhibit button.

Referring to the exhibit what are two reasons for the configuration stanza? (Choose two.)

Ato reduce the risk of forwarding traffic through a stateless tunnel

Bto mark the tunnel down after the hold-time expires

Cto remove the tunnel interface from inet.0 after the hold-time expires

Dto mark the tunnel up after the hold-time expires

Answer : A, B

Which statement about a virtual-router type of routing instance is correct?

AIt is used to separate large networks into smaller administrative entities

BIt is the only routing instance type supported on Junos devices

CIt is used in Layer 3 VPN implementations

DIt is used to create and maintain separate routing and forwarding tables

Answer : D

You want to make use of the nonstop active routing (NSR) feature.

Which complementary feature must also be enabled?

AIP anycast

Bgraceful restart

CVirtual Router Redundancy Protocol

Dgraceful Routing Engine switchover

Answer : D

Click the Exhibit button.

Which type of route is shown in the exhibit?

Agenerate

Bstatic

Ckernel

Daggregate

Answer : A

Which statement correctly describes a characteristic of IPv6 unicast addressing?

AGlobal addresses are in the range of 2002::/16.

BOnly one loopback address exists, ::1/128.

CLink-local addresses are in the range of FF00::/8.

DLink-local addresses are in the range of FE00::/12.

Answer : B

Free Practice Questions for Juniper JN0-362 Exam